A-A-54598
packaged in a suitable case. The complete clipper assembly shall withstand a 3 foot drop on a security line, while clipper is running without evidence of damage or malfunction.
The cutter head shall be attached to, and shall be detachable from, the body top section. The head shall be designed to accommodate different size blade sets. The gear housing of the cutter head shall be covered by a corrosion-resisting steel, brass, or aluminum plate, and shall be held in place by not less than two screws.
The cutting blades shall be furnished in sets consisting of a top blade and a bottom blade, operating as a pair, and shall be fabricated of tool steel. The cutting blades shall be hardened and tempered, and shall have a Rockwell C average hardness of 58-68, when tested in accordance with ASTM E 18. The blades shall be free from cracked or malformed teeth. The edges of holes for screws shall be free from burrs. The head of the blade screw and the ends of the clamping spring screws shall set flush with, or below, the bottom blade surface. Interchanging of the blade sets shall be accomplished with ease.
The blade guard shall be fabricated of plastic, rubber, or corrosion-resisting steel, brass, or aluminum. The blade guard shall cover the blade edges without looseness.
The clipper motor shall be universal wound and intended for 115V-120V, single phase, 50-60 Hz, AC-DC, operation with double insulation or a means of grounding. The rubber covered flexible electrical cord shall be not less than 10 feet long. Cords of double insulated clippers shall have two conductors, with a molded 2-prong male plug. Grounded cords shall have three conductors, with a molded 3-prong male plug. The clipper shall comply with the applicable requirements of UL 1028, Hair Clipping and Shaving Appliances. The molded 3-prong male plug shall conform to ANSI Standard C-73-11.
All clipper fasteners, oil ports, and alignment plates shall be chromium or nickel plated. The blades shall have a flat ground finish. Blade size numbers 10, 15, or 40, as applicable, shall be marked on blades.
Each clipper shall be furnished with the following accessories:
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business